Step into a whimsical woodland adventure with our “Into the Woods” Shaker Card! This card comes alive with delightful confetti that dance with every shake.
Please note: This post contains affiliate links. If you use these links and make a purchase, we earn a commission at no extra cost to you…
My “Into the Woods” shaker card is created with products by Eileen Hull. The die sets worked perfectly with the Fall Harvest toner sheets by Ann Butler Designs, and the Deco Foil from Thermoweb added the beautiful shimmer I was looking for. Although this card may look like a lot of work, you can create it in less than an hour! hope you give it a try. Crafty hugs, Lisa~
Supplies for “Into the Woods” Shaker Card
See the complete supply list at the end of this post.
Steps One, Two, Three:
Cut the cardstock as follows: Rust 4 7/8″ x 6 1/8″ and Dark Green 4 1/4″ x 5 1/2″.
Place the toner papers into a carrier sheet and run them through the laminator one at a time. If you’re new to foiling you can watch my video of this card on our YouTube Channel. Click HERE. Cut the toner papers as follows: Tree Branch 4″ x 5 1/4″ (this is the same size as the plastic shaker cover), and the Pine Branches 4 5/8″ x 6″.
Die cut the window from the Black & Gold toner paper, and the trees and foliage from Dark Green, Light Green, Tan and Dark Brown cardstock.
Steps Four, Five, Six:
Adhere the window image to the tree branch paper. Next, randomly adhere the acrylic leaves to the window. Place the paper into the shaker cover.
Tape the shaker cover closed using double-sided tape around the edges, leaving the bottom open for confetti. Pour the confetti into the shaker and fill as desired. Tape the bottom closed.
Adhere the Pine Branch paper to the Rust cardstock. Next, adhere the shaker cover to the Green cardstock, and then attach it to the card base as shown. Cut a piece of the Black & Gold paper 3 1/2″ x 3/4″. Stamp the sentiment on a scrape piece of White cardstock using the Black inkpad. Cut the sentiment out and adhere it to the Black & Gold paper. To finish, attach the sentiment with foam tape and decorate the card with the trees and foliage. See the photo for placement if needed.
“Into the Woods” Shaker Card
- Cardstock: Rust, Dark Green, Light Green, White
- Ann Butler Designs Toner Papers: Fall Harvest, Black Toner Paper
- Plastic Shaker Cover, (1) from Amazon
- Thermoweb Deco Foil: Copper, Gold Glitter, Grass Green
- Rubber Stamp Sentiment
- Gina K Designs Inkpad, Obsidian
- Fall Theme Confetti
- Mini Acrylic Leaves
- Double-Sided Tape
- Foam Tape
- White Glue
- Eileen Hull Designs Thinlits Dies: #666978, #666979
- Sizzix Big Shot
- Scissors
- Paper Trimmer
- Gina K Designs Fuse Foiling System
One more PIN of the “Into the Woods” Shaker Card to share
